More Fish Leadcore Presentation The Answer
By Wisconsin fishing charter Capt. Jim Hirt
Here are some ways to present lures in spring. This time of year look for most of your fish in the top 50 feet. Keep your eye on your locator and also work deeper marks when you see them. My experience this time of year is the deeper fish are less active and tend not to bite. Should you have a question please e-mail me from my Website contact us page. Read all my articles and see video fish reports at http://www.jimhirt.com
Wake up the Fish
Most often you will not mark well above 30 feet because those fish are out side the cone of your locator’s transducer. The primary presentations I use at this time of year are Church Tackle Walleye boards, Divers and leadcore. If your budget allows, I would recommend trying a leadcore line set up. This presentation will work when all others are dead.
Basics
The basics of leadcore are simple. The most expensive part is the reel. It must have enough line capacity to handle the leadcore line plus Seaguar fluorocarbon and Power Pro 50 pound for a total of anywhere from 300 half core to 600 yards two cores. I run my half cores or five colors on a reel that holds 300 yards of 20 pound test. This is the smallest reel a half core will fit on. Line counter reels are not necessary. Leadcore sinks at a rate of 4-5 feet per color. A half core will run about 24 feet deep.
Loading the reel
When loading this reel, start with 300 yards of Power Pro 50 pound then strip the lead out of the end of the leadcore and tie a Willis Knot to the leadcore. Finish with a Willis Knot and 30 feet of a 20-pound Seaguar fluorocarbon to a ball bearing cross lock snap. You will need a heavy action 8-foot rod to work with lead. You may run this with a Church Tackle Walleye planer board if you are going to use multiple set ups.
Presentation Tips
Snap on your favorite lure and let out all of the line to the Power Pro. Then install your board so it does not release. I usually run them 150 feet off each side of the boat. Very wide turns and low boat traffic are a must to avoid tangles and getting run over. I set my drags light. When the reel starts to scream, adjust the drag as necessary. Reel in the line until you can reach the board and hand release it. Now the line is clear to bring in the fish. I don’t fish lead early in the morning. I use it when the early bite is over. Some of my biggest fish are caught on this presentation.
Hot spoon for Leadcore
If you would like to try the hottest spoons for salmon and trout in 2011 go to http://www.badgertackle.com Good luck. Jim charters out of Milwaukee, WI. with Blue Max Charters. He can be reached at 414-828-1094 or visit his web site at http://www.bluemaxcharters.com Copyright© 2012, James J. Hirt, All Rights Reserved.
By Wisconsin fishing charter Capt. Jim Hirt
In many parts of the world Spring means cold water. As water cools presentation must change for you to be successful. Here are a few tips of mine to get these neutral or less active fish to bite. Should you have a question please e-mail me from my Website contact us page. Read all my articles and see video fish reports at http://www.jimhirt.com
Cold water…. Hot bite
In previous articles we covered general overview and the specifics of temperature breaks and their location. Now let’s continue with spring presentation and location. If your season starts early as we do at Blue Max Charters, you will be on Lake Michigan or your favorite water when the surface temperatures are below the preferred temp of your target species. Concentrations of fish on temp breaks can be great for action.
Breaks and how to fish them
I will cover late May and early June in this article. This time period provides great action on Browns and Rainbows. Browns, at this time of the year, will come on similar presentations, lures and locations as I described in previous articles. Look for temp breaks with bait fish and the warmest water. This time of year you won’t find water that is to warm for Browns. I like small Vulcan spoons with silver, green or white blades with green, orange or blue accent stripes. Work the top 25 feet of water.
Presentation for cold water
I set up 90% of my lines on Church planer boards working the top fifteen feet of water. The remaining 10% of my lines are on diving planers or downriggers for deeper fish. On all my rods in spring, I run a 20-25 pound test monofilament with a 12-pound leader. You need to go with a light leader to produce good action in clear water near the surface. Run the heavier test to a bead chain sinker or barrel swivel then an 8-foot leader with a cross lock snap. I don’t go nuts with Micro Filament or Super Braid lines because I think they are over kill for this application and add to expenses. Starting out this way I will have the rods loaded with the correct line for most presentations through out the season.
Speed part of the answer
I set my boat speed at 1 to 2 mph. Slow presentation is key in spring. The lures you run is all about the amount of light, baitfish size and the size of fish you are looking to catch. Mix it up! When one lure produces I would double up on that lure. For Coho I prefer 6 inch orange flashers and a variety of different colored flies instead of spoons. Adjust the length of the leader from the flasher to the fly to get the best results. The general rule is one and one half times the length of the flasher. My experience is the colder the water the longer the leader. Longer leaders slow down the action of the fly. There are times when I run up to three times the flasher length. Most Rainbows will also hit the flasher flies. When only looking for Rainbows, substitute bright color spoons for flasher flies. If you would like to try the hottest spoons for salmon and trout in 2011 go to http://www.badgertackle.com Good luck. Jim charters out of Milwaukee, WI. with Blue Max Charters. He can be reached at 414-828-1094 or visit his web site at http://www.bluemaxcharters.com Copyright© 2012, James J. Hirt, All Rights Reserved.
After you have let out the line to the distance you would like, attach the board with the clip provided by the manufacturer. Once the board is attached lower the board into the water allowing it to run off to the side of the boat. When the fish strikes you may do one of two things. Do not release the board just reel the board to the rod tip and hand release it. Then finish reeling in your fish. A second option is to release the board, which slides down the line toward the inline weight and stops. The board is reeled in with the fish and the fish is netted.